L3000mm Automatic Pneumatic Pores Stiffeners (reinforcing rib) machine
First , the working conditions
Cylinder diameter : diameter :310-600mm
Workpiece thickness :0.3-0 .6 mm
Maximum barrel length : L = 3000mm
Material : pearl plate , galvanized , stainless steel , fluorine titanium plate .
Second, the technical parameters and requirements
1 Rated voltage : 380VAC 50HZ
2 Rated Power : 0.5KVA
3 the height / width : according to customer requirements,if no special requirements,produced according to conventional requirements .
4 the compressed air pressure : 0.45mMpa
5 the electrical part of the warranty period of one year.
6 pneumatic components AIRTAC .
This equipment is used in the solar water heater tank vacuum tube holes on both sides of each fold a reinforcing rib,the solar water
heater inside the barrel vacuum tube holes on a flat surface , so that the vacuum tube bore to an increase of 2~3 points strength ,
in operation, does not cause the hole deformation reduce scrap rates , sheet bending indentation , without special tooling , the use
of low-cost , installation and operation , and a high degree of flatness .
|
